Air Techniques 2000XR Film Processor

Air Techniques 2000XR Film Processor

The A/T 2000 XR Film Processor provides high quality radiographs in any size. If your practice works with larger size film, A/T 2000XR is the right fit. A/T 2000XR is automatically controlled and highly efficient to keep your practice running smoothly.
Request a quote
Product Details
Specifications
Resources
  • Automatic chemistry replenishment and temperature maintenance
  • A microcomputer automatically signals the internal replenishment pumps to meter the proper amount of developer and fixer to maintain chemistry strength; this ensures optimum chemistry strength and is more economical because excess chemistry is not used
  • Stand-by mode for energy conservation: after films exit the processor, the A/T 2000 XR will automatically return to stand-by mode, reducing electricity use, water consumption and system wear
  • Daylight loader available: the optional Panoramic Daylight Loader and a Quick Loader Covered Feed Chute eliminate the need for a darkroom
  • Process time: Archival, 5-1/2 minutes; "Quick-look" Endo periapical films, 2-1/2 minutes
  • Chemistry replenishment: At initial Power On, 4-1/4 oz in 90 seconds; every 12-3/4" linear film, 1-2/3 oz in 35 seconds
  • Electrical: 115 V, 60 Hz, 8 A; use 3-prong grounded outlet; dedicated 15 amp line recommended
  • Water flow: 1/2 gallon/minute when processing film; do not use water softeners
  • Water pressure: 80 psi max/30 psi min; manual shut-off required near processor
  • Water connection: 1/2" female NP and 3/4" male garden hose adapters provided; a 6' long water supply hose is provided to connect to the rear of the processor
  • Water backflow prevention: Vacuum breaker not required; processor has a 1" air gap between water supply inlet and top of highest water level in processor
  • Water temperature: Mixing valve not required if water temperature is between 55 degrees F (13 degrees C) to 80 degrees F (27 degrees C)
  • Drain: Use 1-1/2" diameter vertical PVC standpipe, open at top, connected to 1-1/2" PVC trap; top of standpipe must be 6" below bottom of counter top. DO NOT DRAIN INTO COPPER OR BRASS
  • Ventilation: Room air must not exceed 80 degrees F (27 degrees C) during processing. Processing generates heat. Adequate ventilation of 10 air changes per hour is necessary to maintain darkroom temperature
  • Dimensions (H x W x D): 18" x 15" x 25" with leveling base. With Daylight loader, 18" x 16.25" x 39"; Daylight Loader extends additional 10.25" below counter top
  • Weight: 90 lb with water and chemistry; 75 lb empty